ABS Filament - Bambu Studio
Introduction
This is a comprehensive materials settings guide to help get started!
The settings listed below have been found to produce the best results using Bambu Labs X1C in our test lab. However, every printer is unique and different, and settings need to be tweaked based on the hardware. Consider these parameters as a solid starting point rather than rigid, foolproof configurations. You can always reach out to us at support@numakers.com if you have any questions.
Drying recommendation
|
Temp (°C) |
80 |
|
Time (h) |
4-6 |
Instructions
Advanced settings enabled. Load the generic ASA profile and make the following modifications.
Settings
Basic information
|
Type |
ABS |
|
Flow ratio |
0.95 |
| Recommended nozzle temperature |
240-280 |
Print temperature
|
Nozzle (first layer/other layers) |
260/265 |
|
Cool plate / PLA plate (first layer/other layers) |
0/0 |
|
Engineering plate (first layer/other layers) |
90/90 |
|
High temp plate (first layer/other layers) |
90/90 |
|
Textured PEI plate (first layer/other layers) |
90/90 |
Volumetric speed limitation
|
Max volumetric speed |
22 |
Cooling for specific layer
|
No cooling for the first |
3 |
Part cooling fan
|
Min fan speed threshold |
10%, 30s |
| Max fan speed threshold |
80%, 3s |
| Keep fan always on |
Yes |
| Slow printing down for better layer cooling |
Yes |
| Min print speed |
20 |
| Force cooling for overhangs and bridges |
Yes |
| Cooling overhang threshold |
25 |
| Fan speed for overhangs |
80 |
Auxiliary part cooling fan
|
Fan speed |
0 |
Retraction
|
Retraction |
Default generic ABS settings |
Recommended printer upgrades
|
Special Nozzle |
None |
|
Bed adhesion |
PEI, Glass Plate, Painter's tape, Glue stick |
|
Heated bed |
Required |
|
Enclosure |
Required |